Mobile drowning aid manual

Nothing more than a bad phone or bad or fell into the water, the former Senecio plants without surgery or prior to the treatment of the latter cell phone into the water, just know how to properly handle, the phone may not be no salvation, if the phone fell into the "drowning" How is it for first aid?
water Accident

Step one: First off, remove the battery

Have been to primary school science, General Studies all know that water is a conductor, will lead to electrical short circuit, in general, is not waterproof phones fall into the water the first ten seconds, the water may not seep into the circuit board inside the phone, the phone still have a chance is turned on, so the phone out from the water, after wiping away a little water, it must be shut down. If the phone battery can be removed if the cap is removed, the battery should be removed.

▲ First, both inside and outside the phone dry.
Step two: remove the Micro-SD and SIM card

After the power is turned off, and the second part is to remove the Micro-SD and SIM card, because the water may penetrate the slot position, but not completely dry to avoid water again when turned on, causing a short circuit to make Micro-SD and SIM card data loss.

▲ In addition to electricity, the water has a chance to stay in the slot, try to remove all the cards from the card slot
Step three: dry machine inside and outside

If the phone is designed to open the lid, then try to wipe the phone apart, some impatient people will try to "fing" cell phone, trying to use centrifugal force, so that the water inside the machine, avoid this behavior, because the water has a chance and therefore The flow into places that do not have to make "expand the scope of the disaster."

Step four: dried

After wipe the phone, you can put the phone on the air, a cool place for about 3-5 days to dry naturally, such as mobile phones. Similarly, some impatient people will want to use duct hot air can accelerate water evaporation, which can really speed up the hand copies of evaporation, but to pay attention to, whether the phone is falling into the water or salt water, salt water, how much there is, and salt will make the metal oxide in your phone, if coupled with the hot air will make the strengthening of the chemical reaction, so that the solder joints and metal oxide in the chip on the board, even if the phone will save a substantial Life Lost. That the use of duct cool wind, the water flow is also likely to spread to, so the best way to dry naturally.

Step Five: Reboot

After a few days after air drying, before rebooting, the best re-examination and contact with tissue Mama bit different then boot.

▲ bit due to possible contact from the dry period may have some oxidation, so wiping away oxide.
ps over the water into the phone as ever, almost always the durability of the phone number, unfortunate, then, after she can boot, then he bought another phone, the phone data transfer, the better to sell the phone into the water.